JETI ECO 12

The Jeti Eco 12 brushless speed controller for brushless motors is a simple and economical speed controller supporting 2-3 cell lithium polymer batteries and offers control of the most common programming options.

The Jeti Eco 12 amp controller features a built-in linear BEC. This provides the receiver and servos with a 5.0v power-supply directly from your 2 or 3 cell Li-Po battery, eliminating the need for a separate receiver battery. The Eco 12 is not fitted with an arming switch, so always disconnect your flight battery after flying (A good habit to establish!)

Jeti Eco brushless motor controllers also feature a power cut-off system, which cuts power to the motor of your RC plane when the voltage of your lithium battery indicates that it is nearly depleted. This feature conserves power for your receiver and servos, allowing you short bursts of motor power and full control of your radio controlled model to bring it down safely.

Jeti 'Eco' speed controllers feature special software, which allows precise control of timing automatically. No programming is required to achieve the correct timing for your brushless motor.

Built-in temperature overload protection cuts power to your brushless motor, should the temperature of the controller exceed 100°C. This feature is designed to prevent failure of the controller due to over-heating. Always ensure a good supply of air flowing over the controller to maintain an even temperature during flight.

The Jeti Eco 12 supports four modes of operation, selected using the included jumper plug: -

• Mode 1:
  • Battery Type: NiCd/NiMH Batteries
  • Brake: OFF
  • Cut-off Type: Slow down
  • Cut-off Voltage: 5 Volts or 0.7v/cell
• Mode 2:
  • Battery Type: NiCd/NiMH Batteries
  • Brake: ON
  • Cut-off Type: Stop
  • Cut-off Voltage: 5 Volts or 0.7v/cell
• Mode 3:
  • Battery Type: Li-Po/Li-Ion Batteries
  • Brake: OFF
  • Cut-off Type: Slow down
  • Cut-off Voltage: 6 volts for 2-cells, 9 volts for 3-cells
• Mode 4:
  • Battery Type: Li-Po/Li-Ion Batteries
  • Brake: ON
  • Cut-off Type: Stop
  • Cut-off Voltage: 6 volts for 2-cells, 9 volts for 3-cells

Toimitetaan ilman liittimiä.